10" x 4.5" Replacement Water Filter for Sediment, Dirt, Rust - Deep Grooves for 1 Year Life

Upgraded 5 Micron Sediment Filter Whole House 10″ Filter Housings

The BG-10SED is a 10 inch jumbo 5 micron polypropylene melt blown sediment cartridge. This replacement water filter reduces sediment, dirt, rust and more from your water. It's an excellent choice for residential, rural, municipal, and commercial applications. The grooved design increases surface area which gives it a very high dirt holding capacity. It is easily installed and fits just like the Aquapure original (and performs better too)! Fits all standard large diameter (4.5 inch) 10″ water filter housings including the Aqua Pure AP801.

• High dirt holding capacity
• Up to twice the filter life compared to the 3M Aqua Pure AP810
• The grooved design extends the water filter cartridge life and increases water filtration efficiency due to the increased surface area
• Deep ridges are industrial grade construction that holds up in stressful conditions
• The construction helps to eliminate sediment “unloading” that often happens due to variations in water pressure
• Large-diameter (4.5″), 5 micron sediment filter that is an effective method for reducing turbidity in water
• Removes sediment, dirt, rust, and other particulate matter as small as 5 microns that are commonly found in drinking water
• Ideal for light commercial applications, and large homes (2.5 baths)
• Perfect fit for whole house water filter models like the Aqua Pure AP801 and Aqua Pure AP801-1.5
• Compatible with all standard, jumbo 10″ housings
• Provides a sufficient supply of purified water throughout the day with its impressive flow rate (20 – 28 gallons per minute)

• Capacity: 20 gallons per minute
• Size 4.5″ D X 9.75″ L
• Flow rate: 20-28 gallons per minute (gpm)

Please refer to your units’ manual for replacement cartridge installation instructions, but as a general guideline, the installation instructions below are applicable for most whole house units including the Aqua Pure AP801 .

1. Turn off incoming water by isolating unit with existing valves on water distribution system.
2. Bleed pressure from the unit by depressing the red button on the top of the unit.
3. Remove housing by sliding wrench up towards head then turn to the left to unscrew.
4. Wipe housing clean and insert BG-10SED.
5. Lubricate o-ring and screw housing head.
6. Turn water back on.